Home > Lavatube Mod > Lavatube V4 VV MOD

Lavatube V4 VV MOD

  • Lavatube 2.0/v2
  • Lavatube V4 VV MOD

Product Abstract:

The Lava Tube Variable Voltage MOD is the one of the most value-priced Mod in its class. The Lava Tube is a Variable Voltage E-Cig that allows you to set the voltage output in increments of 0.1V. You can go from 3.0V-6.0V with just a few clicks of a switch.


Product Description

The Lava Tube Variable Voltage MOD is the one of the most value-priced Mod in its class. The Lava Tube is a Variable Voltage E-Cig that allows you to set the voltage output in increments of 0.1V. You can go from 3.0V-6.0V with just a few clicks of a switch. Set it to your preferred vaping voltage and puff away. The Standard unit uses a high capacity IMR 18650 battery while the Mini version uses a IMR 18350 battery 

Each e-Smokey Treats Lava Tube Variable Voltage Kit contains:

 1 Lava Tube Variable Voltage MOD (Mini or Standard)

1 Battery Charger

2 High Drain IMR batteries (18650 for the Standard and 18350 for the Mini)

1 eGo Carrying case

2  6ml  clearomizer 0r 2 ce4 clearomizer

Please note: Some 18650 will not fit into this unit. The 18650 battery must be 18mm x 65mm in order to fit. Most 18650 batteries are slightly longer than 65mm. Also, we suggest using atomizers or cartomizers of 2.5ohm or higher.

The e-Smokey Treats lava Tube is packed Features:
Aluminum body
1- power button
1- voltage up button
1- voltage down button
1- activation button
1- LCD screen, which shows the current voltage the device is set on.
1- 510 threaded connection
1- vented removable end cap w/ spring for battery tension


Tech Specs:
Selectable voltage from 3v to 6v in 0.1v increments

Power on/Off Button:  hold the button down for 5 seconds to turn the device on, hold the button again for 5 seconds to turn the device off.

+ Button: On press, increases voltage by .1 increments between 3volt and 6 volt.

- Button:On press, decreases voltage by .1 increments between 3volt and 6 volt.

+ and – Button: Press and hold both buttons for five second to disable the + and – button, locking the device on the voltage it is currently set at.

Regulated output: Keeps the voltage the same with each puff regardless of the remaining battery power. As the battery drains, the device will keep the voltage consistent.

10 Second Cutoff timer: If the activation button is held down for 10 seconds or longer, the Lava Tube will shut itself off until the button is released. To prevent overheating the atomizer and the device.

Short Circuit/Atomizer Protection: The Lava Tube can recognize an atomizer with too low of a resistance for the current voltage setting and will drop the voltage to 3.7v to protect both the battery and atomizer. If the atomizer is too low or shorted out it will shut off power to the device to protect the Lava Tube from being damaged.

Reverse Battery Protection:  Protects the device in case you put the battery in the device backwards

BatteryMonitoring/Over-Discharge Protection: The device will monitor the battery voltage and automatically turn off when the battery is discharged, preventing damage to the battery by overly depleting it.

BatteryVoltage Meter: The Lava Tube has a voltage meter built in, simply press the red power button 6 times and it will display the voltage of the battery for a few seconds. This way you can monitor the power left in the battery before it needs to be recharged. 18650 batteries provide 4.2V at peak charge and over the life of the battery that voltage will decrease to about 3.3v level before needing to be recharged.  This will help you monitor the life cycle of the battery. The LCD screen will flash when the battery needs to be recharged, and will stop powering the device.

Amperage Limiting to 2.5 amps:  The device should monitor and shut itself off if it detects any excessive over-current conditions.

Vent hole on the bottom of the device for added safety

Related Products

Inquiry Information

  • *Subject:

  • *Content:

  • *Telephone Number:

  • *Your E-Mail:

  • *Confirm Text:

    captcha

Contact Us